Toyota Celica 2000 Repair Manual page 454

-
MANUAL TAANSAXLE{C60)
3. Vehicle speed sensor drive gear side:
INSTALL TAPERED ROLLER BEARING
Place the vehicle speed sensor drive gear in position to
(a )
stop it turning, and install the vehicle speed sensor drive
gear.
NOTICE:
Be sure to install the vehicle speed sensor drive gear in the
correct direction, as shown in the Illustration.
Using SST and a press, install a new side bearing.
(b)
SST
NOTICE:
When replacing the tapered roller bearing outer race, re�
place the tapered roller bearing along with it.
HINT:
Set SST to the bearing inner race securely.
Case Si d e
INSTALL RING GEAR ON DIFFERENTIAL CASE
4.
Clean the contact surface of the differential case.
(a)
Heat the ring gear in boiling water.
(b)
.... .
Carefu!!y take the ring gear out of the wateL
(c)
After the moisture on the ring gear has completely evapo-
(d)
rated, quickly instal! the ring gear to the differential case.
HINT:
Align the matct1rnarks on the differential case and contact the
ring gear.
Temporarily install the 8 set bolts.
(e)
CAUTION:
The ring gear set bolts should not be tightened until the
ring gear has cooled sufficiently.
After the ring gear has cooled sufficiently, torque the ring
(f)
gear set bolts uniformly at a time.
Torque: 77 N·m (790 kgf.cm, 57 fl·lbf)
5. INSPECT DIFFERENTIAL TAPERED ROLLER BEAR-
ING PRELOAD
NOTICE:
Perform this only when replacing the tapered roller bearing
and outer race of the differential case.
(a) Install the differential case assembly to the transaxle
case.
Install the transmission case to the transaxle case with
(b)
the 1 6 bolts.
Torque: 29 N-m (300 kgf.cm, 22 fl·lbf)
DlfH:: R ENTIALCASE
0931 6-6001 1 (0931 6-0001 1 ). 09350-32 0 1 4
(09351-321 20)
MX-53