Toyota Celica 2000 Repair Manual page 97

EM-92
-
CYLINDER BLOCK
ENGINE MECHANICAl
Lay a strip of Plastigage the crank pin.
(f)
Install the connecting rod cap with the 2 bolts (See page
(g )
EM-106).
Torque:
1st:
1ZZ-FE: 20 N·m (204 kgf . cm, 15 ft.lbf)
2ZZ-GE: 30 N·m (306 kgf . cm, 22 ft.lbf)
2nd: Turn extra 90°
NOTICE:
Do not turn the crankshaft.
Remove the 2 bolts, connecting rod cap and lower bear­
(h)
n
.
i (See procedure (b) and (c) above)
g
�
Measure the Plastigage at its widest point.
(i)
Standard oil clearance:
1ZZ-FE:
0.028 - 0.060 mm (0.0011 - 0.0024 in.)
2ZZ-GE:
0.028 - 0.052 mm (0.0011 - 0.0020 ln.)
Maximum oil clearance;
0.08 mm (0.0031 ln.)
lf the oil clearance is greater than maximum, replace the bear­
ings. If necessary, grind or replace the crankshaft.