Table of Contents
Advertisement
ATC sensor PCB bracket removal
Remove the printer front door. See
1.
2.
Remove the transfer belt cleaner. See
Remove the waste toner box.
3.
Remove the four photoconductor units.
4.
Remove the four toner supplies.
5.
Remove the operator panel front cover. See
6.
7.
Remove the printhead retract door. See
Remove the inner cover. See
8.
Remove the two screws from the ATC sensor PCB bracket (A).
9.
Disconnect the five cables (B) from the ATC sensor PCB bracket.
10.
"Printer front door removal" on page
"Transfer belt cleaner removal" on page
"Operator panel front cover (MFP) removal" on page
"Printhead retract door removal" on page
"Inner cover removal" on page
A
B
4-13.
4-178.
4-145.
4-4.
Repair information
7558-xxx
Previous
Next
4-8.
Go Back
4-29
Advertisement
Table of Contents
