Table of Contents
Advertisement
7558-xxx
Remove the K toner auger.
13.
Re-installation note: Ensure that the rubber sleeve (C) is attached properly to prevent toner spillage.
LED printhead removal
Remove the printer front door. See
1.
Remove the transfer belt cleaner. See
2.
Remove the waste toner box.
3.
4.
Remove the four photoconductor units.
Remove the four toner supplies.
5.
Remove the operator panel front cover. See
6.
Remove the printhead retract door. See
7.
Remove the inner cover. See
8.
9.
Remove the inner plate. See
Remove the appropriate developer unit. See
10.
"Developer housing (M) removal" on page
"Developer housing (K) removal" on page
Service Manual
4-102
C
"Printer front door removal" on page
"Transfer belt cleaner removal" on page
"Operator panel front cover (MFP) removal" on page
"Printhead retract door removal" on page
"Inner cover removal" on page
"Inner plate removal" on page
"Developer housing (C) removal" on page
4-61,
"Developer housing (Y) removal" on page
4-55.
4-13.
4-178.
4-145.
4-4.
4-98.
Previous
Next
Go Back
4-8.
4-49,
4-67, or
Advertisement
Table of Contents
