Hcf Separation Drive Gear Kit Removal - Lexmark X95 series Service Manual

7558-xxx
Remove the sensor (tray 5 feedout) (A).
7.

HCF separation drive gear kit removal

1. Remove the HCF media tray assembly from the printer. See
page 4-436.
Remove the HCF feed unit. See
2.
Remove the HCF feed lift motor. See
3.
4. Remove the HCF lift feed gear bracket. See
Remove the shaft (A) from the HCF lift feed gear bracket (B).
5.
Note: Bearing (C) may become detached.
6. Use a prying tool to remove the e-clip securing the separation gear -19 tooth (D) to shaft (A).
Remove the separation gear - 19 tooth (D).
7.
Remove the bushing (E).
8.
Service Manual
4-444
A
"HCF feed unit removal" on page
"HCF feed lift motor removal" on page
"HCF feed lift gear bracket removal" on page
Connector
B
"HCF media tray assembly removal" on
4-432.
4-430.
Previous
Next
Go Back
4-430.