Table of Contents
Advertisement
7558-xxx
Remove the printhead retract door. See
7.
8.
Remove the inner cover. See
Remove the inner plate. See
9.
10.
Lift the plastic gate, and push it in to prevent the toner from spilling.
Release the two latches (A) connecting the upper portion of the auger.
11.
12.
Detach the lower portion (B) of the auger from the developer unit.
Warning: The lower portion of the auger is prone to damage. Extra care is required in handling this part.
Service Manual
4-200
"Printhead retract door removal" on page
"Inner cover removal" on page
"Inner plate removal" on page
4-145.
4-4.
4-98.
A
B
Previous
Next
Go Back
Advertisement
Table of Contents
