Table of Contents
Advertisement
Disconnect the four cables (C) from the operator panel.
7.
Operator panel PCBA (MFP) removal
Warning: If you are replacing the operator panel PCBA in addition to the operator panel or the RIP PCBA, you
must replace one component at a time. After you replace one component, perform a POR on the
device before replacing a second component. If you replace the components simultaneously, the
printer will be rendered inoperable.
Remove the operator panel right cover. See
1.
Remove the operator panel left cover. See
2.
3.
Remove the operator panel front cover. See
Remove the operator panel. See
4.
Remove the four screws (A) securing the operator panel to the assembly.
5.
"Operator panel right cover removal" on page
"Operator panel left cover removal" on page
"Operator panel front cover (MFP) removal" on page
"Operator panel top cover (MFP) removal" on page
7558-xxx
4-11.
4-10.
4-8.
4-11.
Repair information
4-131
Previous
Next
Go Back
Advertisement
Table of Contents
