Table of Contents
Advertisement
Move the appropriate wiper in and out to clean the printhead.
•
Developer housing rear plunger removal
1.
Remove the rear upper cover. See
Remove the PC/developer drive motor. See
2.
Remove the operator panel left cover. See
1.
Remove the operator panel right cover. See
2.
Remove the operator panel front cover. See
3.
4.
Remove the top cover. See
Remove the printer front door. See
5.
Remove the transfer belt cleaner. See
6.
Remove the waste toner box.
7.
Remove the four photoconductor units.
8.
9.
Remove the four toner supplies.
Remove the printhead retract door. See
10.
Remove the CMYK toner dispense auger assembly. See
11.
removal" on page
"Rear upper cover removal" on page
"PC/developer drive motor removal" on page
"Operator panel left cover removal" on page
"Operator panel right cover removal" on page
"Operator panel front cover (MFP) removal" on page
"Printer top cover removal" on page
"Printer front door removal" on page
"Transfer belt cleaner removal" on page
"Printhead retract door removal" on page
4-41.
4-19.
4-15.
4-13.
4-178.
"CMYK toner dispense auger assembly
Repair information
7558-xxx
Previous
Next
Go Back
4-138.
4-10.
4-11.
4-8.
4-145.
4-73
Advertisement
Table of Contents
