Table of Contents
Advertisement
Reinstallation notes:
Make sure the flat spot on the media entrance roll assembly (H) is installed to the rear.
•
•
When replacing the media entrance roll assembly (H), do not touch the rubber surface.
The tension of the belt (entrance/paddle) (E) is automatically adjusted to the force of the spring attached to
•
the belt tensioner bracket (D).
Tighten the two screws in the order shown.
•
Finisher PCBA removal
Remove the rear upper cover. See
1.
Remove the rear lower cover. See
2.
Loosen the four screws securing the plate (A) to the finisher.
3.
4.
Move the plate (A) to the right and outward.
Remove the plate (A).
5.
"Rear upper cover removal" on page
"Upper media bin front cover removal" on page
A
4-380.
4-423.
Rear
Repair information
7558-xxx
Previous
Next
Go Back
4-353
Advertisement
Table of Contents
