Table of Contents
Advertisement
1xx service error codes
Error code
115.12
Service printhead
error
115.13
Service printhead
error
115.14
Service printhead
error
115.15
Service tray error
120.01
Service fuser error
120.02
Service fuser error
121.01
Service fuser error
121.03
Service fuser error
121.04
Service fuser error
121.05
Service fuser error
121.06
Service fuser error
121.07
Service fuser error
Description
Single LED printhead communication
failure
Multiple LED printhead clock failure
Single LED printhead clock failure
Tray module logic failure
Fuser motor failure
Fuser pressure roll retract motor failure
Encoder pulse fail
Heat belt (center) disconnection error
Heat belt (center) overheat error
Heat belt (rear) disconnection error
Heat belt (rear) overheat error
Heat belt (center) temperature
increase failure
Action
Communication failed between the upper
engine PCBA and one LED printhead.
Go to
"115.12 Single LED printhead
communication failure" on page
Synchronization failed on multiple LED
printheads.
Go to
"115.13 Multiple LED printhead
clock failure" on page
2-52.
Synchronization failed on one LED
printhead.
Go to
"115.14 Single LED printhead
clock failure" on page
2-53.
An error was detected in the tray module.
Go to
"115.15 Tray module logic failure"
on page
2-54.
An error was detected in the fuser motor.
Go to
"120.01 Fuser motor failure" on
page
2-54.
An error was detected at the fuser
pressure rolls and motor.
Go to
"120.02 Fuser pressure roll retract
motor failure" on page
2-55.
No change was detected on the speed of
the belt for more than 1 second.
Go to
"121.01 Encoder pulse failure" on
page
2-55.
Open circuit is detected at the fuser heat
belt.
Go to
"121.03 Heat belt (center)
disconnection error" on page
Temperature in the heat belt has exceeded
the limit.
Go to
"121.04 Heat belt (center)
overheat error" on page
2-56.
Open circuit is detected at the fuser heat
belt.
Go to
"121.05 Heat belt (rear)
disconnection error" on page
Temperature in the heat belt has exceeded
the limit.
Go to
"121.06 Heat belt (rear) overheat
error" on page
2-57.
The temperature is late in reaching a
specified temperature within the specified
time.
Go to
"121.07 Heat belt (center)
temperature increase failure" on
page
2-58.
Diagnostic information
7558-xxx
Previous
Next
2-52.
Go Back
2-56.
2-57.
2-15
Advertisement
Table of Contents
