Input Tray Tests; Feed Tests (Input Tray); Next; Motor Tests - Lexmark X95 series Service Manual

INPUT TRAY TESTS

Feed Tests (Input Tray)

This test is used to observe the paper path of media as it passes through the printer. To observe the paper path,
a user can open the upper rear door while this test executes. No information is printed on the feed test pages
since the printhead LED isn't engaged during this test.
To run this test:
1. From the Diagnostics Menu, navigate to INPUT TRAY TESTS.
Select the appropriate input source from the following choices:
2.
Tray 1
•
Tray 2
•
Tray 3
•
• Tray 4
Multi-Purpose Feeder
•
Touch either Single or Continuous.
3.
Single—Feeds one sheet of media from the selected source.
•
Continuous—Media continues feeding from the selected source until Stop is pressed.
•

MOTOR TESTS

PRINTER MOTOR TESTS

To run these tests:
From the Diagnostics Menu, navigate to MOTOR TESTS.
1.
Select PRINTER MOTOR TESTS.
2.
Select the test from the following options:
3.
Available printer motor tests:
• Fuser/lower redrive/1st transfer
retract motor
• Registration motor
• Tray 1 feed/lift motor (feed)
• Tray 1 feed/lift motor (lift)
• Tray 2 feed/lift motor (feed)
• Tray 2 feed/lift motor (lift)
• Tray 3 feed/lift motor (feed)
• Tray 3 feed/lift motor (lift)
• Tray 4 feed/lift motor (feed)
• Tray 4 feed/lift motor (lift)
• MPF feed/lift motor (feed)
• MPF feed/lift motor (pick)
• Registration clutch
• Upper redrive diverter gate
• Duplex motor (reverse)
• Upper redrive motor (forward)
• Upper redrive motor (reverse)
• Lower redrive shift motor (forward)
• Lower redrive shift motor (reverse)
• Printer transport motor
• HCF feed/lift motor (feed)
• HCF feed/lift motor (lift)
• HCF transport motor
• KCMY drum & transfer belt motor
• Y erase lamp
• M erase lamp
• C erase lamp
• K erase lamp
• Waste toner agitator motor
• Image density sensor shutter open
• Image density sensor shutter close
• Y toner dispense motor
• M toner dispense motor
• C toner dispense motor
• K toner dispense motor
• Developer motor
• Transfer belt motor
• 1st transfer rollers retract motor (contacted)
7558-xxx
Previous
Go Back
Diagnostic aids
3-23

Next