Table of Contents
Advertisement
7558-xxx
Release the two clamps (C) to release the harness.
4.
Swing the PCBA door open.
5.
Pull the main power GFI interface out of the machine, and swing it out of the way. See the
6.
GFI interface removal" on page
Note: The cables do not have to be removed from the main power GFI interface to remove this part.
Remove the PC/developer drive motor. See the
7.
8.
Disconnect the cable (D) from the waste toner agitator motor.
Release the harness from the clamp (E).
9.
Remove the two screws (F) securing the motor cover to the machine.
10.
Remove the motor cover.
11.
Service Manual
4-192
4-119.
"PC/developer drive motor removal" on page
Previous
Next
Go Back
"Main power
4-138.
Advertisement
Table of Contents
