Stapling One Sheet; Stapling Multiple Size Media; Media Limits For Stapling; Stapler Operation - Lexmark X95 series Service Manual

Hide thumbs Also See for X95 series:

Table of Contents

The following table shows media sizes and the applicability of stapling for each staple position.

11 x 17 in. SEF

8.5 x 11 in. LEF

8K SEF(GCO), 16K LEF(GCO)

B4 SEF, B5 LEF

8 x 10 in. LEF

8.5 x 14 in. SEF / 8.5 x 13 in. SEF /

8.5 x 11 in. SEF

8 x 10 in. SEF

Yes: Applicable, No: Not applicable

Stapling one sheet

Upon receiving the stapling command from the printer with one sheet remaining on the compiler unit assembly,

the finisher ejects the media to the stacker media bin without stapling it.

When sheets with different sizes and the same width (example: A4L and A3S) are present on the compiler unit

assembly, all the sheets are stapled and then ejected to the stacker media bin.

When sheets with different widths are present on the compiler unit assembly, stapling is stopped when a

different width is detected. Such different-width sheets are forcibly ejected to the stacker media bin.

The number of sheets to be stapled is limited to prevent damage to the stapler.

• If the number of sheets of one set to be stapled exceeds the limit of the compiler unit assembly, the

exceeding sheets are not stacked on the compiler unit assembly, and are forcibly ejected to the stacker

media bin without being stapled.

• After the forcible ejection of media, if the number of following sheets of one set to be stapled exceeds the

limit of the compiler unit assembly, the exceeding sheets are also ejected forcibly to the stacker media bin

without being stapled.

• After that, even if the number of following sheets of one set to be stapled falls within the limit, the sheets are

also ejected forcibly to the stacker media bin without being stapled.

The upper limit (and default) of the compiler unit assembly media capacity when stapling is 50 (variable (10 to

100) by the non-volatile memory).

The stapler stays at the front home position, that is, at the front staple (corner) position when the power is

The stapler starts stapling when a set of sheets to be stapled is stacked on the compiler unit assembly.

The stapler does not move during stapling in the front staple mode.

Service Manual