Table of Contents
Advertisement
7558-xxx
Tighten the two screws in the order shown.
•
Stepper motor (entrance/paddle) and belt (entrance/paddle) removal
Remove the rear upper cover. See
1.
Loosen the two screws securing the belt tensioner bracket (A) to the finisher and move upward, as shown.
2.
Remove the belt (entrance/paddle) (B) from the stepper motor (entrance/paddle) (C).
3.
Disconnect the connector from the stepper motor (entrance/paddle) (C).
4.
Service Manual
4-416
Connector
"Rear upper cover removal" on page
B
A
Second
First
E
B
4-380.
C
A
Previous
Next
Go Back
Advertisement
Table of Contents
