Table of Contents
Advertisement
Remove the two screws securing the bracket (A) to the finisher.
8.
9.
Remove the bracket (A).
Disconnect the connector from the sensor (diverter gate) (B).
10.
11.
Remove the screw securing the sensor (diverter gate) (B) to the bracket (A).
A
Remove the sensor (diverter gate) (B).
12.
Sensor (finisher media entrance) removal
Open the front door assembly.
1.
Remove the rear upper cover. See
2.
Remove the upper media bin assembly. See
3.
4.
Remove the top cover. See
Remove the left lower cover. See
5.
Remove the left upper cover. See
6.
Disconnect the connector from the sensor (finisher media entrance) (A).
7.
Release the harness from the clamp.
8.
Connector
B
"Rear upper cover removal" on page
"Top cover removal" on page
"Left lower cover removal" on page
"Left upper cover removal" on page
Left
"Upper media bin assembly removal" on page
4-421.
4-359.
7558-xxx
4-380.
4-422.
4-360.
Repair information
4-391
Previous
Next
Go Back
Advertisement
Table of Contents
