Table of Contents
Advertisement
7558-xxx
Remove the plate (A).
5.
6.
Move the slip clutch gear 24T (B) toward the rear to disengage the stacker bin (C).
Move the stacker bin (C) to the lowest position.
7.
Note: Make sure the stacker bin (C) is at the lowest position before continuing.
8.
Disconnect the connector from the sensor (stacker bin level encoder) (D).
Release the harness from the clamps.
9.
Disconnect the connector (P8305) from the finisher controller card assembly (E).
10.
Remove the screw securing the bracket (F) to the stacker bin lift motor assembly (G).
11.
Service Manual
4-408
B
Rear
C
P8305
E
Clamp
D
Clamp
Previous
Next
Go Back
Advertisement
Table of Contents
