Sensor (Booklet Media Entrance) Lag Jam - Lexmark X95 series Service Manual

491.05 Sensor (booklet media entrance) lag jam

Step Action and questions
Check the sensor (booklet media
1
entrance) for proper operation.
1. Enter the Diagnostics Menu.
2. Touch SENSOR TESTS.
3. Touch FINISHER SENSOR
TESTS.
3. Touch Sensor (booklet media
entrance).
Does the display on the
operator panel change every
time the sensing area of the
above sensor is interrupted or
blocked?
Check the sensor (booklet media
2
entrance) for proper connection.
Is the above component
properly connected?
Check the booklet entrance
3
motor for proper operation.
When performing
motor tests, ensure
that all cover and
door interlock
switches are
overridden.
1. Enter the Diagnostics Menu.
2. Touch MOTOR TESTS.
3. Touch FINISHER MOTOR
TESTS.
4. Touch Booklet entrance
motor.
Does the above component
operate properly?
Check the booklet entrance
4
motor for proper connection.
Is the above component
properly connected?
Check the booklet unit interface
5
contact for proper connection.
Is the above component
properly connected?
Check the booklet controller card
6
assembly for proper connection.
Is the above component
properly connected?
Yes
Go to Step 3.
Replace the sensor (booklet
media entrance).
Go to
"Sensor (booklet media
entrance) removal" on
page 4-386.
Go to step 5.
Replace the booklet entrance
motor.
Go to
"Booklet media entrance
drive motor removal" on
page 4-329.
Go to Step 6.
Replace the booklet controller
card assembly).
Go to
"Booklet controller card
assembly removal" on
page 4-322.
Go to step 7.
7558-xxx
No
Go to Step 2.
Replace connections.
Go to step 4.
Replace connections.
Replace the booklet unit interface
contact.
Replace the connections.
Diagnostic information
Previous
Next
Go Back
2-235