Model 6C4 Drawer-Release Latch And Brackets - IBM pSeries 630 6C4 Service Manual

Model 6C4 Drawer-Release Latch and Brackets

The following procedure covers the removal and replacement of the system's drawer-release latch.
Drawer-Release Latch Removal
To remove one of the Model 6C4 drawer-release latches, do the following:
1. Open the front rack door and place the system into the service position as described in "Placing the
Model 6C4 into the Service Position" on page 429.
2. Remove the retaining screw located on the side of the release latch.
3. Pull the release latch off the latch bracket post.
1 System Drawer-Release Latch
2 System Drawer-Release Latch
Bracket (Right)
3 Model 6C4
4 System Drawer-Release Latch
Bracket (Left)
5 System Drawer-Release Latch
6 Retaining Screws
7 Release Latch Retaining Screw
8 Latch Bracket Post
Chapter 9. Removal and Replacement Procedures
427