IBM pSeries 630 6C4 Service Manual page 200

Checkpoint
E532
E533
E534
180 Eserver pSeries 630 Model 6C4 and Model 6E4 Service Guide
Description
RIO cable detected; enable the RIO hub
port
Set up the RIO hub routing table
Get the node ID of the node on the other
end of the RIO cable
Action/
Possible Failing FRU
1. Replace the RIO-2 cable specified by
the location code.
2. Replace the RIO riser card that the
failing drawer is attached to.
3. Replace the RIO riser card (location:
U0.dd-P1.1) in the I/O subsystem that
the RIO cable in step 1 is attached to.
4. If the location code associated with this
checkpoint specifies a PCI adapter
card, replace the adapter card.
5. Replace the I/O subsystem planar that
the RIO-2 cable in step 1 is attached to.
6. Go to "MAP 1540: Problem Isolation
Procedures" on page 124.
1. Replace the RIO-2 cable specified by
the location code.
2. Replace the RIO riser card that the
failing drawer is attached to.
3. Replace the RIO riser card (location:
U0.dd-P1.1) in the I/O subsystem that
the RIO cable in step 1 is attached to.
4. If the location code associated with this
checkpoint specifies a PCI adapter
card, replace the adapter card.
5. Replace the I/O subsystem planar that
the RIO-2 cable in step 1 is attached to.
6. Go to "MAP 1540: Problem Isolation
Procedures" on page 124.
1. This error code may indicate that the
RIO cables are not properly connected
to the I/O subsystems. Check the RIO
cabling.
2. Replace the RIO-2 cable specified by
the location code.
3. Replace the RIO riser card that the
failing drawer is attached to.
4. Replace the RIO riser card (location:
U0.dd-P1.1) in the I/O subsystem that
the RIO cable in step 1 is attached to.
5. If the location code associated with this
checkpoint specifies a PCI adapter
card, replace the adapter card.
6. Replace the I/O subsystem planar that
the RIO-2 cable in step 1 is attached to.
7. Go to "MAP 1540: Problem Isolation
Procedures" on page 124.