IBM pSeries 630 6C4 Service Manual page 363

Error Code Description
B1xx 4694 System processor firmware failure
B1xx 4695 System power control network to service
processor interface failure
B1xx 4696 System firmware interface failure
B1xx 4698 Firmware problem
B1xx 4699 Service processor firmware error or informational
message.
B1xx 469A System firmware interface
B1xx 469B Firmware to I/O interface
B1xx 469C Firmware to I/O interface
B1xx 469E Service processor firmware failure
B1xx 469F Service processor failure
B1xx 8FF0 Informational message
B1xx A2D0 Write operation to the LPAR data area in
NVRAM failed
Action/
Possible Failing FRU
1. Check for system firmware updates.
2. CEC backplane
Location: U0.1-P1
1. Check for system firmware updates.
2. CEC backplane
Location: U0.1-P1
1. Check for system firmware updates.
2. Call service support.
1. Check for system firmware updates.
2. Call service support.
See B1xx 4699 in "Error Code B1xx 4699" on
page 344.
1. Check for system firmware updates.
2. Call service support.
1. Check for system firmware updates.
2. CEC backplane
Location: U0.1-P1
1. Check for system firmware updates.
2. CEC backplane
Location: U0.1-P1
1. Check for system firmware updates.
2. Go to "MAP 1540: Problem Isolation
Procedures" on page 124, CEC minimum
configuration
3. CEC backplane
Location: U0.1-P1
1. Check for system firmware updates.
2. Go to "MAP 1540: Problem Isolation
Procedures" on page 124, CEC minimum
configuration
3. CEC backplane
Location: U0.1-P1
See B1xx 8FF0 in "Error Code B1xx 8FF0" on
page 348.
1. Using the HMC, perform a soft reset on the
partition that reported this error.
2. Using the HMC, perform a hard reset on the
partition that reported this error.
3. If the attempts to reset the partition are not
successful, shut down all partitions, then
remove and reapply AC power to the system.
4. Reboot the system.
Chapter 5. Error Code to FRU Index
343