Map 154B: Insufficient Hardware Resources Problem Isolation; Step 154B-1; Step 154B-2; Step 154B-3 - IBM pSeries 630 6C4 Service Manual

MAP 154B: Insufficient Hardware Resources Problem Isolation

Step 154B-1

Record the error code, location code(s) and word 13 that sent you to this MAP.

Step 154B-2

Turn off the power.

Step 154B-3

Make sure the power is off on the base system drawer.

Step 154B-4

Attention: Before replacing any parts, examine the base system drawer for violation of any of the
following configuration constraints.
v At least one 1-way processor is installed.
v At least one quad of DIMMs is installed on any of the installed processor cards at locations:
U0.1-P1-Cx-My, where x is 1 or 2 and y is 1, 3, 6, and 8 on the same processor card.
v Quads are populated in DIMM slots 1, 3, 6, 8 first, and then in slots 2, 4, 5, 7
Replace the following cards, if present, one at a time:
v First location code item recorded, if any, in "Step 154B-1".
v Second location code item recorded, if any, in "Step 154B-1".
v Third location code item recorded, if any, in "Step 154B-1".
v If the value of word 13, recorded in "Step 154B-1", is 402F0000, 403F0000, or 40FF0000, replace the
following, if installed:
– Processor card 1 at location U0.1-P1-C1, if not recorded in "Step 154B-1".
– Processor card 2 at location U0.1-P1-C2, if not recorded in "Step 154B-1".
v If the value of word 13, recorded in "Step 154B-1", is 40600000, replace the processor backplane at
U0.1-P1, if not recorded in "Step 154B-1".
v If the value of word 13, recorded in "Step 154B-1", is 41100000, replace the processor backplane at
U0.1-P1, if not recorded in "Step 154B-1".
v Memory DIMMs at locations U0.1-P1-C1-M1, M3, M6, M8, if not recorded in "Step 154B-1".
v Memory DIMMs at locations U0.1-P1-C1-M2, M4, M5, M7, if not recorded in "Step 154B-1".
v Processor backplane at U0.1-P1, if not recorded in "Step 154B-1".

Step 154B-5

Turn on the power.

Step 154B-6

Did the system stop with the same error code as recorded in "Step 154B-1"?
No The card just replaced was defective. This ends the procedure.
Go to "MAP 0410: Repair Checkout" in the RS/6000 Eserver pSeries Diagnostic Information for
Multiple Bus Systems.
Yes Go to "Step 154B-7" on page 156.
Chapter 3. Maintenance Analysis Procedures (MAPs)
155