IBM pSeries 630 6C4 Service Manual page 243
Hide thumbs
Also See for pSeries 630 6C4:
- Installation manual (180 pages) ,
- Quick setup instructions manual (13 pages) ,
- User manual (233 pages)
Table of Contents
Advertisement
Table 3. SPCN Error Codes for I/O Subsystems
Error Code Description
1nn1 00AC AC loss or brownout detected
1nn1 00EF Remote emergency power off occurred
1nn1 1510 Power supply 1 source failure
1nn1 1511 Power supply 1 fault
1nn1 1512 Power supply 1 non-power fault
1nn1 1513 Power supply 1 domain fault
1nn1 1517 Power supply 1 thermal fault
1nn1 1520 Power supply 2 source failure
1nn1 1521 Power supply 2 fault
1nn1 1522 Power supply 2 non-power fault
1nn1 1523 Power supply 2 domain fault
1nn1 1527 Power supply 2 thermal fault
1nn1 1B01 +12 V load fault
1nn1 1B02 +5 V load fault
Action/
Possible Failing FRU
Informational message.
Informational message.
1.
Check the input voltage to the power supply.
2. I/O subsystem power supply 1, U0.dd-V1.
3. I/O subsystem backplane, U0.dd-P1.
1. I/O subsystem power supply 1, U0.dd-V1.
2. I/O subsystem backplane, U0.dd-P1.
1. I/O subsystem power supply 1, U0.dd-V1.
2. I/O subsystem backplane, U0.dd-P1.
1. I/O subsystem power supply 1, U0.dd-V1.
2. I/O subsystem backplane, U0.dd-P1.
1. Check for obstructions to the air flow around
the I/O subsystem.
2. I/O subsystem power supply 1, U0.dd-V1.
3. I/O subsystem backplane, U0.dd-P1.
1. Check the input voltage to the power supply.
2. I/O subsystem power supply 2, U0.dd-V2.
3. I/O subsystem backplane, U0.dd-P1.
1. I/O subsystem power supply 2, U0.dd-V2.
2. I/O subsystem backplane, U0.dd-P1.
1. I/O subsystem power supply 2, U0.dd-V2.
2. I/O subsystem backplane, U0.dd-P1.
1. I/O subsystem power supply 2, U0.dd-V2.
2. I/O subsystem backplane, U0.dd-P1.
1. Check for obstructions to the air flow around
the I/O subsystem.
2. I/O subsystem power supply 2, U0.dd-V2.
3. I/O subsystem backplane, U0.dd-P1.
1. Replace power supply 1, U0.dd-V1.
2. If power supply 2 is present, use power
supply 1 that was removed to replace power
supply 2.
3. I/O subsystem backplane, U0.dd-P1.
1. Replace power supply 1, U0.dd-V1.
2. If power supply 2 is present, use power
supply 1 that was removed to replace power
supply 2.
3. I/O subsystem backplane, U0.dd-P1.
Chapter 5. Error Code to FRU Index
223
Advertisement
Chapters
Table of Contents
