IBM pSeries 630 6C4 Service Manual page 605

5. Lift the RIO-2 cable and cable connector into the bottom of the RIO-2 cable support bracket.
6. Pull the RIO-2 connector back until the connector is seated against the support hook.
7. Push the RIO-2 connector forward, ensuring that the RIO-2 connector lever slides over the top of the
connector hooks.
8. Slowly push the assembly toward the chassis.
9. Secure with the captive thumbscrew, the RIO-2 connector and slide portion of the RIO-2 support
bracket to the back of the Model 6C4 chassis.
1 Model 6C4
2 RIO-2 Cable Support Bracket
3 Slide Portion of RIO-2 Cable Support Bracket
4 RIO-2 Connector Support Lever
1 Captive Thumbscrews
2 RIO-2 Cable and Connector
3 RIO-2 Connector Support Lever
Appendix D. Setting Up the System
585