Bezel-release latch
Before you begin:
v Read "Safety information" on page 131
v Review the information in "System reliability considerations" on page 37
To remove the bezel-release latch, complete the following steps:
1. Turn off the server, if it is on.
2. Unplug the server, and disconnect the power cord; then, disconnect all external
3. Remove the side cover. See "Removing the side cover" on page 41
4. Remove the front bezel. See "Removing the front bezel" on page 42
5. Remove the CD-ROM drive. See "CD-ROM drive" on page 95
6. Pull down from inside the server to release the latch tab.
7. From the underside, grasp the bezel-release latch in the center, and gently pull
98
IBM xSeries 225 Type 8647: Hardware Maintenance Manual and Troubleshooting Guide
cables.
it back and away from the server.