IBM pSeries 630 6C4 Service Manual page 273

Table 5. Service Processor Error Codes. (continued)
Error Code Description
4064 0C10 Processor 0 configuration error: VPD mismatch
for processor card 0. (Service processor code
problem.)
4064 0C11 Processor 1 configuration error: VPD mismatch
for processor card 1. (Service processor code
problem.)
4064 0CA5 Invalid system configuration
4064 0CA6 No usable memory left in the system. The
system must be rebooted.
40640 CA9 Incorrect/incompatible memory DIMMs are
installed.
4064 0CAA System memory exceeds the limit for this
system type and model.
4064 0EA0 MOPS service processor code error.
4064 0EA1 Operating system code on main processor
4064 0EA2 PRD code on service processor error.
4064 0EA4 The service processor detected a problem, but
was unable to isolate the source.
4064 0EAF Service processor code and system type are
unknown
4064 0EB0 JTAG problem
4064 0EB1 Attention line 0 stuck fault
4064 0EB2 Attention line 1 stuck fault
4064 0EB3 Attention line 2 stuck fault
4064 0EB4 Attention line 3 stuck fault
4064 0EB5 Attention line 4 stuck fault
Action/
Possible Failing FRU
1. Check for system firmware updates.
2. Call service support.
1. Check for system firmware updates.
2. Call service support.
1. Check that the processor cards and memory
DIMMs are properly installed and configured.
2. If there are any FRUs listed in the service
processor error log entry, replace them one
at a time.
3. Go to "MAP 1540: Problem Isolation
Procedures" on page 124.
Go to "MAP 1240: Memory Problem Resolution"
on page 73.
Check that the memory DIMMs are properly
configured, and are the right type for the system.
Remove the memory DIMMs until the memory
does not exceed the limit for this system type
and model.
1. Check for system firmware updates.
2. Call service support.
1. Check for operating system code updates.
2. If there are other symptoms, go (one
symptom at a time) to the "Quick Entry MAP"
on page 63 and follow the instructions.
3. Call service support.
1. Check for system firmware updates.
2. Call service support.
Contact next level of support.
1. Check for system firmware updates.
2. Call service support.
Go to "MAP 1541: JTAG Problem Isolation" on
page 126.
Go to "MAP 1540: Problem Isolation Procedures"
on page 124.
Go to "MAP 1540: Problem Isolation Procedures"
on page 124.
Go to "MAP 1540: Problem Isolation Procedures"
on page 124.
Go to "MAP 1540: Problem Isolation Procedures"
on page 124.
Go to "MAP 1540: Problem Isolation Procedures"
on page 124.
Chapter 5. Error Code to FRU Index
253