IBM pSeries 630 6C4 Service Manual page 357

Error Code Description
B10F 1380 Service processor program failure
B10F 1381 Service processor flash error
B10F 1384 Service processor failure
B10F 1387 Service processor failure
B10F 1400 Service processor failure
B10F 1401 Service processor failure
B10F 1670 Service processor flash update failure
B10F 1672 Service processor firmware update invalid
B10F 1675 Service processor failure
B10F 1681 Service processor firmware update invalid
B10F 1682 Service processor firmware update invalid
B10F 1683 Service processor firmware update invalid
B1xx 0013 An attempt was made to flash (update) the
firmware from AIX using the wrong image for this
system. No flashing took place; the firmware
level was not changed.
B1xx 4600 Service processor failure
B1xx 4601 System processor failure
B1xx 4602 Description: Hardware failure
Actions:
1. Was this error code logged just after the system crashed?
NO
YES
2. Examine the service processor error log. Look for a 4xxx yyyy error that calls out FRU(s) in the
CEC whose timestamp just precedes the B1xx 4602 error. If a 4xxx yyyy error occurred,
replace the FRU indicated by the location code. If there is no 4xxx yyyy error whose timestamp
just precedes the B1xx 4602 error, continue to step 3.
3. Reboot the system in slow mode to the SMS menus. See "Performing Slow Boot" on page 209.
a. Examine the service processor error logs. Look for a 4xxx yyyy error that occurred during
the slow boot that calls out FRU(s) in the CEC.
b. If a 4xxx yyyy error occurred during the slow boot, replace the FRU(s) indicated by the
location code(s).
c. If a 4xxx yyyy error did not occur during the slow boot, replace the system planar, U0.1-P1.
Go to step 3.
Go to step 2.
Action/
Possible Failing FRU
1. Update system firmware
2. CEC backplane
Location: U0.1-P1
1. Update system firmware
2. CEC backplane
Location: U0.1-P1
CEC backplane
Location: U0.1-P1
CEC backplane
Location: U0.1-P1
CEC backplane
Location: U0.1-P1
CEC backplane
Location: U0.1-P1
1. Retry flash update
2. CEC backplane
Location: U0.1-P1
Call service support
CEC backplane
Location: U0.1-P1
Call service support
Call service support
Call service support
Retry the firmware update from AIX using the
correct flash image.
CEC backplane
Location: U0.1-P1
Go to "MAP 1540: Problem Isolation Procedures"
on page 124.
Chapter 5. Error Code to FRU Index
337