IBM pSeries 630 6C4 Service Manual page 219
Hide thumbs
Also See for pSeries 630 6C4:
- Installation manual (180 pages) ,
- Quick setup instructions manual (13 pages) ,
- User manual (233 pages)
Table of Contents
Advertisement
Checkpoint
E5E0
E5E1
E5E2
E5E3
E5E4
E5E5
E5E6
E5E7
E5E8
E5E9
E5EE
E5EF
E5FE
Description
Initialize system processor array
Reserved
Initialization of the hypervisor, phase 1
Not in quick-restart: load and set up open
firmware code in memory
Activate slave processors
Initialize the hypervisor, phase 2
Set L2 and processor status
Save I/O hub information for RTAS and
open firmware
Set up registers
Reset the quick restart path
Hang state in main control code
End of low-level firmware
Get the system's licensed memory quantity
from the service processor
Action/
Possible Failing FRU
1. Check for system firmware updates.
2. Replace the I/O subsystem's RIO riser
card (location: U0.dd-P1.1) specified by
the location code.
3. Replace the I/O subsystem backplane
specified by the location code.
4. Go to "MAP 1540: Problem Isolation
Procedures" on page 124.
1. Check for system firmware updates.
2. Go to "MAP 1540: Problem Isolation
Procedures" on page 124.
1. Check for system firmware updates.
2. Go to "MAP 1540: Problem Isolation
Procedures" on page 124.
1. Check for system firmware updates.
2. Go to "MAP 1540: Problem Isolation
Procedures" on page 124.
1. Check for system firmware updates.
2. Go to "MAP 1540: Problem Isolation
Procedures" on page 124.
1. Check for system firmware updates.
2. Go to "MAP 1540: Problem Isolation
Procedures" on page 124.
1. Check for system firmware updates.
2. Go to "MAP 1540: Problem Isolation
Procedures" on page 124.
1. Check for system firmware updates.
2. Go to "MAP 1540: Problem Isolation
Procedures" on page 124.
1. Check for system firmware updates.
2. Go to "MAP 1540: Problem Isolation
Procedures" on page 124.
1. Check for system firmware updates.
2. Go to "MAP 1540: Problem Isolation
Procedures" on page 124.
1. Check for system firmware updates.
2. Go to "MAP 1540: Problem Isolation
Procedures" on page 124.
1. Remove, then reapply AC power to the
system using the UEPO switch.
2. Verify that the CUoD capacity card is
installed and properly seated.
3. Call service support.
Chapter 4. Checkpoints
199
Advertisement
Chapters
Table of Contents
