Resetting The Leds - IBM pSeries 630 6C4 Service Manual

See the following illustration for RIO connector LED locations on the rear of the Model 6C4 and Model
6E4.
The following table defines the on and off status of the PCI-X adapter LEDs.
PCI Adapter Table
LED Inactivity
Green + Amber (2 Green - Off
LEDs) Amber - Off

Resetting the LEDs

After the repair action is completed, do the following:
1. Log in as root user.
2. At the command line, type diag.
3. Select Task Selection.
4. Select Log Repair Action.
5. Select the device that was repaired.
6. Press F10 to exit diagnostics.
If the Attention LED remains on after you have completed the repair action and reset the LEDs, call for
service support.
1 RIO-2 0 Identify LED
2 System Drawer Rear Power LED
3 System Drawer Rear Attention LED
4 RIO-2 1 Identify LED
Active
Green - On
Amber - Off
Identify Action
Green - On Green - Off
Amber - Blinking Amber - Blinking
Chapter 12. Fault and Attention LEDs
547