IBM pSeries 630 6C4 Service Manual page 254

Table 4. Firmware Error Codes. (continued)
Error Code Description
20EE 0020 The environment variable "boot-device"
exceeds the allowed character limit.
20EE 0021 The environment variable "boot-device"
contained more than five entries.
20EE 0022 The environment variable "boot-device"
contained an entry that exceeded 255
characters in length.
20EE 0100 Fcode resident on an I/O adapter is not
supported on this system
20FC 0020 Failed to retrieve power, packaging, and/or
cooling VPD via SPCN for the corresponding
subsystem.
Service processor mailbox failed to get VPD.
234 Eserver pSeries 630 Model 6C4 and Model 6E4 Service Guide
Action/
Possible Failing FRU
If this error occurs during the installation of AIX
via a "NIM push", the set_bootlist attribute may
not have been set correctly on the NIM master.
For more information, see the AIX Installation
Guide and Reference, order number
SC23-4389.
If this error occurs at any other time:
1. Check for platform firmware updates. Apply
if available.
2. Call service support.
If this error occurs during the installation of AIX
via a "NIM push", the set_bootlist attribute may
not have been set correctly on the NIM master.
For more information, see the AIX Installation
Guide and Reference, order number
SC23-4389.
If this error occurs at any other time:
1. Check for platform firmware updates. Apply
if available.
2. Call service support.
If this error occurs during the installation of AIX
via a "NIM push", the set_bootlist attribute may
not have been set correctly on the NIM master.
For more information, see the AIX Installation
Guide and Reference, order number
SC23-4389.
If this error occurs at any other time:
1. Check for platform firmware updates. Apply
if available.
2. Call service support.
Informational message. The adapter's Fcode
driver is not supported on this system.
Additional information may be available from
service support.
This error code only affects boot-time operation,
not the adapter's functionality under the
operating system.
1. Check the RIO cabling.
2. Check for system firmware updates.
3. Replace the RIO riser card (location:
U0.dd-P1.1) in the I/O subsystem that the
RIO cable in step 1 is attached to.
4. Replace the I/O backplane that the RIO
cable in step 1 is attached to.
5. Replace the CEC backplane, U0.1-P1.