Top Cover Removal (Model 6E4) - IBM pSeries 630 6C4 Service Manual

Top Cover Removal (Model 6E4)

To remove the top cover, do the following:
1. Remove the bezel door as described in "Bezel Door Removal" on page 441.
2. Remove the front bezel as described in "Front Bezel Removal (Model 6E4)" on page 443.
3. Remove the top cap as described in "Top Cap Removal (Model 6E4)" on page 432.
4. Remove the operator panel as described in "Operator Panel Removal" on page 484.
5. Remove the two retaining screws that secure the operator-panel EMC bracket to the operator-panel
bracket.
6. Remove the four retaining screws that secure the operator-panel bracket to the top cover.
7. Remove the four retaining screws that secure the top cover to the system chassis.
8. Remove the front screw that secures the top cover to the right panel assembly. This screw is located
on the front inside edge of the system, just below the top cover.
9. Remove the back cover as described in "Back Cover Removal (Model 6E4)" on page 437.
10. From the back of the system, remove the rear screw that secures the top cover to the right panel
assembly. This screw is located on the rear inside edge of the system, just below the top cover.
11. From the back of the system, remove the two retaining screws that secure the top cover to the
system top-cover rear bracket.
12. Lift the top cover up and off the system chassis.
1 Top Cap
2 Operator Panel EMC Bracket
3 Operator Panel
4 Operator Panel Bracket
5 Top Cover
6 Model 6E4
7 Bezel Door
8 Bezel
9 Rear Top Cover Mounting Bracket
10 Rear Cover
Chapter 9. Removal and Replacement Procedures
433