Network Configuration; Configure Static Ip Address Using The Device - Xerox WorkCentre 5755 System Administrator Manual

Network Installation

Network Configuration

This section explains how to set up the device to operate in a Windows TCP/IP environment. The
following information is provided:
•

Configure Static IP Address using the Device

• Configure Dynamic Addressing
• Configure IP Settings using Internet Services
• IPv4 on page 84
• IPv6 on page 85
• Configure SLP on page 88
• Configure FTP on page 89
• SNMP (Simple Network Management Protocol)
• SSDP (Simple Service Discovery Protocol)
• Microsoft Networking
• LPR/LPD on page 98
• Raw TCP/IP Printing
• SMTP (Simple Mail Transfer Protocol)
• LDAP on page 103
• Configure POP3 Setup
• Configure HTTP on page 110
• Proxy Server on page 111
• NTP on page 112
• WSD on page 113
• Apple Talk on page 114
• NetWare on page 115
• AS400 Raw TCP/IP Printing to Port 9100 (CRTDEVPRT)
• UNIX on page 121
Note: The device supports IP versions 4 and 6. IPv6 can be used instead of or in addition to IPv4.
IPv4 Settings can be configured directly at the device user interface, or remotely, via a web
browser using Internet Services. IPv6 can only be configured using Internet Services. To configure
TCP/IP Settings using Internet Services, see
page 84.
Configure Static IP Address using the Device
Information Checklist
Before starting the procedure, ensure the following items are available or tasks have been performed:
• Existing operational network utilizing the TCP/IP protocol.
• Ensure that the device is connected to the network.
80 Xerox WorkCentre 5735/5740/5745/5755/5765/5775/5790
System Administrator Guide
on page 82
on page 95
on page 96
on page 100
on page 101
on page 109
on page 80
on page 84
on page 90
on page 118
Configure IP Settings using Internet Services on