Xerox WorkCentre 5755 System Administrator Manual page 91

Installation via DHCP (Dynamic Host Configuration Protocol)
DHCP is enabled on the device by default. If the device is connected to the network, the TCP/IP
information will be configured when the device is powered on and no further configuration is required.
Print a Configuration Report to verify that TCP/IP information is correct.
1. Press the <Machine Status> button on the device.
2. Touch the [Machine Information] tab.
3. Touch [Print Reports].
4. Touch [Print Report].
5. Touch [Close].
The Configuration Report will print. On the report verify the details under Network Setup heading are
correct.
Installation via BOOTP or DHCP
Ensure your device is connected to the network with Ethernet cabling.
Note: To configure this feature or these settings access the Tools pathway as a System
Administrator. For details, refer to
1. From the Tools pathway, touch [Network Settings].
2. Touch [TCP IP].
3. Touch [TCP/IP Settings].
4. Touch [Automatic Addressing]. By default, DHCP is selected.
5. Select one of the following required Dynamic Addressing methods:
• BOOTP
• DHCP
• RARP
6. Touch [Save].
7. Touch [Close].
8. Press the <Log In/Out> button.
9. Touch [Logout] to exit the Tools pathway.
Access Tools Pathway as a System Administrator
Xerox WorkCentre 5735/5740/5745/5755/5765/5775/5790
Network Installation
on page 10.
System Administrator Guide
83