Xerox WorkCentre 5755 System Administrator Manual page 180

Security
Security Policies: To Enable IP Sec
Note: IP Sec cannot be enabled until SSL (Secure Sockets Layer) is enabled on the device. To
enable SSL on a device, the device needs to have a Server Certificate. For instructions to set up a
Server Certificate, refer to
Note: To configure this feature or these settings access the Properties tab as a System
Administrator. For details, refer to
1. From the Properties tab, click on the [Security] link.
2. Select [IP Sec] in the directory tree.
3. Ensure [Security Policies] tab is highlighted under the IPsec heading.
4. In the Settings area, check the [Enabled] checkbox for Enablement enable the IP Sec.
5. Click on the [Apply] button.
Note: It is recommended that IP Sec is enabled after the Host Groups, Protocol Groups and Action
have been configured and defined.
Define Policy
An IPsec Policy is a set of conditions, configuration options and security settings which allows two
systems to agree on how to secure traffic between them. Multiple policies can be simultaneously
active, however the scope and policy list order may alter the overall policy behavior.
Note: Before creating Policies, configure Host Groups, Protocol Groups and Actions.
6. In the Define Policy area, there are three policy options:
• Hosts Groups
• Protocol Groups
• Action
This area allows you to select settings for allowing or disallowing Hosts and Protocols and what
action to be taken.
7. For each individual option select settings from each drop-down menu.
Click on the [Add Policy] button.
8.
Saved Policies
9. In the Saved Policies area, there will be a list of all the policies saved.
10. To delete a policy, highlight the policy and click on the [Delete] button.
11. Also you can prioritise an individual policy by clicking the [Promote] and [Demote] buttons.
Disable IP Sec at the device
Note: To configure this feature or these settings access the Tools pathway as a System
Administrator. For details, refer to
1. From the Tools pathway, touch [Network Settings].
Touch [IP Sec].
2.
3. Touch [Disable], then touch [Save].
4. Press the <Log In/Out> button.
5. Touch [Logout] to exit the Tools pathway.
172 Xerox WorkCentre 5735/5740/5745/5755/5765/5775/5790
System Administrator Guide
Machine Digital Certificate Management
Access Internet Services as System Administrator
Access Tools Pathway as a System Administrator
on page 167.
on page 16.
on page 10.