Xerox WorkCentre 5755 System Administrator Manual page 191

3. Touch [Print Reports].
4. Touch [Print Report].
5. Touch [Close].
On the Configuration Report, check under the Installed Options heading if On Demand Image
Overwrite is an installed and enabled option.
To Perform an Image Overwrite at the Device
This procedure will overwrite the image data from the hard disk. This excludes Embedded Fax data,
when this feature is installed on the device.
Note: All existing jobs (excluding Embedded Fax), regardless of their state are deleted and all job
submission is prohibited for the duration of the overwrite. Do not switch off the device while
image overwrite is in progress.
Note: The device must not be in diagnostics mode when the Overwrite is started.
Diagnostics Mode is used by a Customer Service Representative when servicing the device.
At the Device:
Note: To configure this feature or these settings access the Tools pathway as a System
Administrator. For details, refer to
1. From the Tools pathway, touch [Security Settings].
2. Touch [On Demand Overwrite].
3. Select one of the following:
• Standard Image Overwrite
• Full Image Overwrite
a. Touch [Start Image Overwrite] to start the Image Overwrite process.
b. The Image Overwrite Confirmation screen display. Touch [Overwrite] to begin. The device
will be taken offline and will be unable to receive any incoming jobs.
c. Following completion of the Overwrite the On Demand Overwrite completion screen appears.
Touch [Close]. The network controller will reboot and network functionality will be
unavailable for several minutes.
When rebooted, the Disk Overwrite confirmation report is printed. This details the status and time
of the overwrite.
To verify the overwrite has completed view the Confirmation Sheet, under Confirmation Details.
The Job Information: Status ESS Disk should read 'SUCCESS'.
Access Tools Pathway as a System Administrator
Xerox WorkCentre 5735/5740/5745/5755/5765/5775/5790
on page 10.
System Administrator Guide
Security
183