Xerox WorkCentre 5755 System Administrator Manual page 124

Network Installation
5. In the Service Advertising Protocol (SAP) area:
a. For Protocol, check the [Enabled] checkbox if you wish to enable SAP protocol.
SAP is used to inform other network devices about the device's available services. If SAP is
disabled, the device will not send out periodic SAP broadcast messages
b. Set the SAP periodic broadcast frequency in the [SAP Frequency] field. The range is from 15 -
300 seconds, or enter 0 for none. The default is 60.
SAP allows service-providing nodes, such as file servers, print servers, gateway servers and
application servers to advertise their services and addresses. The Service Advertising Protocol
(SAP) is included in the Internetwork Packet Exchange (IPX) protocol. SAP makes the process of
adding and removing services on an IPX internetwork dynamic.
6. In the Bindery Settings area, if using NetWare in Bindery mode (when NDS tree and NDS context
are not used), you can set which file server the device will use for the Binder service. You can enter
the names of up to four primary [File Servers] for the device in the Bindery Settings field.
7. NetWare Directory Services (NDS) is a system designed to make management of large networks
easier for Administrators. NDS allows users, groups, files, directories, and other local and remote
resources to be displayed in a hierarchical tree structure.
In the NetWare Directory Services (NDS) area:
a. If IP is selected for the [Filing Transport] in the General area, select either IPv4 Address or
Host Name.
b. In the [NDS Server (For Server FAX and Workflow Scanning only)] fields, if you selected
[IPv4 Address], enter the IP Address of the NDS server. If you selected [Host Name], enter
the host name of the NetWare server.
c. In the [NDS Tree] field, enter the name for the NDS tree.
Note: If you are using Bindery or Bindery emulation, leave this field blank. If you are using NDS,
this field cannot be left blank. The default tree name is "Xerox_DS_Tree".
d. In the [NDS Context] field, enter the name for the NDS context.
Note: If you are using Bindery or Bindery emulation, leave this field blank. If you are using NDS,
this field cannot be left blank. The default context name is "Xerox_DS_Context".
8. Click on the [Apply] button to accept the changes or [Undo] to return the settings to their
previous values.
9. Click on the [OK] button when you see the message "Properties have been successfully
modified".
NDPS/NEPS
For The Xerox NDPS/NEPS Agent, documentation, and Print Drivers visit the Xerox website at
www.xerox.com.
Novell Distributed Print Services (NDPS)/Novell Enterprise Print Services (NEPS) are products built on
Novell's printing architecture.
These products allow System Administrators to take advantage of built-in printer intelligence to
centrally manage network printing resources from anywhere on the network, improve network printing
performance, and reduce the difficulty of network printing for end users.
116 Xerox WorkCentre 5735/5740/5745/5755/5765/5775/5790
System Administrator Guide