Network Installation
•
Authentication Failure Generic Traps (Status: Enabled)
Note:
When Authentication Failure Generic Traps is disabled, traps of this type will not be sent
by this Device. To enable Authentication Failure Generic Traps, go to SNMP Properties from the
main SNMP Configuration page.
5.
Click on the [Save] button to save settings and return to the Advanced Settings page.
6.
Click on the [Back] button to return to the SNMP page.
7.
Click on the [Apply] button to accept the changes or [Undo] to return the settings to their
previous values.
8.
Click on the [OK] button when you see the message "Properties have been successfully
modified".
94
Xerox WorkCentre 5735/5740/5745/5755/5765/5775/5790
System Administrator Guide