Network Installation
Windows 2000/2003 using AppleTalk
Information Checklist
Before starting the procedure, ensure the following items are available or tasks have been performed:
•
An existing operational AppleTalk network with Macintosh workstation computers equipped with
Ethernet network interface cards.
•
The AppleTalk Name you wish to assign to your printer.
•
The AppleTalk Zone (if used) in which your printer will reside.
•
Ethernet Cable.
•
The Internet Services Print and Fax Drivers CD (delivered with your device). Review any README
file contained with the Print Drivers.
At the Device
Note:
To configure this feature or these settings access the Tools pathway as a System
Administrator. For details, refer to
1.
From the Tools pathway, touch [Network Settings].
2.
Touch [Network Setup].
3.
Touch [AppleTalk Settings], the AppleTalk (R) Settings screen displays.
4.
Touch [AppleTalk (R) Enablement].
5.
Touch [Enable] for Protocol.
6.
Touch [Save] to return to AppleTalk (R) Settings screen.
7.
Touch [Name and Area].
8.
Touch [Printer Name] field and enter the desired text using the on-screen keyboard, touch the
[Save] button.
9.
Touch [Area Name] field, enter the desired text using the on-screen keyboard, (the printer default
is * which means the printer will appear in ALL areas). Use the C hard button to clear out the
default name prior to entering your new name).
10. Touch [Save].
11. Touch [Save] again, touch [Close].
12. Press the <Log In/Out> button, touch [Logout] to exit the Tools pathway.
13. Wait few minutes for the machine to reboot. Press the <Machine Status> button.
a.
Touch the [Machine Information] tab.
b.
Touch [Print Reports].
c.
Touch [Print Report].
d.
Touch [Close].
The Configuration Report will print. On the report verify the details under Network Setup
heading are correct.
64
Xerox WorkCentre 5735/5740/5745/5755/5765/5775/5790
System Administrator Guide
Access Tools Pathway as a System Administrator
on page 10.