Rear Final Drive Removal - Honda 2005 FOURTRAX FOREMAN TRX500 TM Service Manual

REAR DRIVING MECHANISM
BRAKE PANEL
Remove the snap ring.
Drive the axle bearings out of the brake panel.
Support the bear- Drive the outer bearing (brake drum side) squarely
ing housing section with the sealed side facing down until it is fully
of the brake panel seated, then the inner bearing with the sealed side
when installing, facing up.
TOOLS:
Driver
Oil seal driver attachment
Pilot 28 mm
07749-0010000
07JAD-PH80100
07746-0041100
Install the snap ring with the chamfered side facing
to the bearing securely.
Apply grease to a new dust seal lips.
Install the dust seal with the flat side facing up until
it is flush with the brake panel.
ATTACHMENT
SNAP RING
REAR FINAL DRIVE REMOVAL
Drain the final gear case oil (page 4-14).
Remove the rear axle (page 17-7).
Remove the brake panel breather hose from the
clamps.
Support the swingarm and remove the right shock
absorber lower mounting bolt.
Remove the eight nuts, four bolts and right axle
housing.
Remove the O-ring from the rear final gear case.
LOWER MOUNTING BOLT
RIGHT AXLE
HOUSING
17-10