Honda 2005 FOURTRAX FOREMAN TRX500 TM Service Manual page 110

FUEL SYSTEM
Check the starting enrichment (SE) valve face for
scores, scratches or wear.
Check the SE valve seat at the tip of the valve for
stepped wear.
Check the seal ring for deterioration, wear or dam-
age.
Replace the SE valve set if necessary.
Install the SE valve into the carburetor and tighten
the SE valve nut.
TORQUE: 2.3 N-m (0.23 kgfm, 1.7 Ibfft)
Connect the fuel hose to the carburetor.
Clamp the carburetor heater and throttle position
sensor wires as shown.
Connect the throttle position sensor connector.
Connect the carburetor heater 2P connector and
install it onto the frame stay.
Install the air cleaner housing (page 6-5).
Perform the following inspections and adjustments:
- engine idle speed (page 4-13)
- throttle operation (page 4-5)
Adjust the pilot screw if it was replaced (page 6-19).
SE VALVE NUT CLAMP
CONNECTOR \
CARBURETOR HEATER 2P CONNECTOR
6-18