Honda 2005 FOURTRAX FOREMAN TRX500 TM Service Manual page 345

REAR DRIVING MECHANISM
Place the driver, attachment and pilot on the top of
the bearing and tape the driver to the compressor.
TOOLS:
Driver
Attachment, 22 x 24 mm
Pilot, 15 mm
07749-0010000
07746-0010800
07746-0040300
Place the bearing and tool assembly into a freezer
for at least 30 minutes.
Heat the gear case to 80°C (176°F).
Remove the bearing and tool assembly from the
freezer and drive the bearing into the gear case
using the special tools.
Only strike the driver once. If you strike it more than
once, the ring may slip out of the groove. If this hap-
pens, remove the ring and bearing, and install a
new ring.
Make sure the stopper ring is securely set in the
groove of the gear case.
DRIVER
COMPRESSOR
ATTACHMENT, PILOT
STOPPER RING
17-19