Honda 2005 FOURTRAX FOREMAN TRX500 TM Service Manual page 123

ENGINE REMOVAL/INSTALLATION
FM/ME models
only:
Install the mounting rubbers on the left lower
engine mounting rubber with the large I.D. side fac-
ing in.
Install the hanger bracket, bolts, left lower engine
hanger bolt and nut.
Install the mounting rubbers onto the upper engine
hanger bracket with the large I.D. side facing in.
Install the upper engine hanger bracket, bolts and
nut.
Tighten the engine hanger nuts and bolts as fol-
lows:
1. left and right lower engine hanger nut
TORQUE: 54 Nm (5.5 kgf-m, 40 Ibfft)
2. left lower engine hanger bracket bolts
TORQUE: 32 Nm (3.3 kgf m, 24 Ibfft)
3. engine side upper engine hanger bolts
TORQUE: 32 Nm (3.3 kgf m, 24 Ibfft)
4. frame side upper engine hanger nut
TORQUE: 54 Nm (5.5 kgf-m, 40 Ibfft)
Install the spark plug cap onto the plug.
Install the universal joint boot onto the engine.
Install the boot band and screw, and tighten the
screw securely.
MOUNTING RUBBERS
JWPF
HANGER BRACKET HANGER NUT, BOLT
Install a new stopper ring into the propeller shaft
groove.
Apply 5 - 8 g of molybdenum disulfide grease to the
outer ring splines of the front final clutch.
Apply molybdenum disulfide grease to the propeller
shaft splines.
Install the propeller shaft into the outer ring by
aligning the splines until the stopper ring seats in
the groove.
UNIVERSAL JOINT BOOT
7-9