Rear Final Drive Removal - Honda TRX500FM Service Manual

Suppon the bearing
housing section of
the brake panel
when installing.
Apply grease to the lips of a new dust seal [1].
Install the dust seal with the metal plate side facing up
until it is flush with Ihe housing end .
TOOLS :
[2J Driver
[3] Attachment, 62 x 68 mm
Remove the snap ring [1].
07749-0010000
07746-0010500
Drive Ihe bearings [2] oul of the brake panel.
Drive a new bearing into the brake panel with the
sealed side facing down (brake drum side).
TOOLS:
(3J Driver
(4] Oil seal driver attachment
[5) Pitot, 28 mm
07749·0010000
07JAD·PH80101
07746-0041100
Drive a new bearing with the sealed side facing up (axle
housing side) using the same tools.
Install the snap ring into the groove with the chamfered
edge facing the bearing .
Apply grease to the seal lips of a new dust seal [1].
Install the dust seal into the brake panel so that it is
flush with the brake panel.
REAR FINAL DRIVE REMOVAL
Drain the gear case oil if the final gear case will be , - -
disassembled (page 3-17).
Remove the rear axle (page 20-7).
Support the swingarm and remove the following:
- breather hose (1 ) (from the gear case)
REAR DRIVING MECHANISM
20-9