Reverse Shift Switch - Honda 2005 FOURTRAX FOREMAN TRX500 TM Service Manual

ELECTRIC SHIFT PROGRAM (ESP/FE model)
Check for continuity between the switch side con-
nector terminals w i t h each switch pushed.
Continuity should exist between the color coded
wires as f o l l o w s :
Color
Switch Position
UPSHIFT pushed
DOWNSHIFT pushed
White/red
a-
White/blue
White/
yellow
•o
INPUT VOLTAGE
Remove the front fender (page 3-9).
Remove the handlebar switch 10P green connector
from the frame and disconnect it.
Turn the ignition switch to ON.
Measure the input voltage between the Black/red
wire terminal (+) of the harness side connector and
ground (-).
STANDARD: 4.7 - 5.3 V
If the input voltage is abnormal, or if there is no
input voltage, check for an open or short circuit in
the wire harness, or loose or poor connections in
the wire harness.
REVERSE SHIFT SWITCH
INSPECTION
Remove the engine sub-wire harness 2P green con-
nector from the frame and disconnect it.
Check for continuity between the Gray wire terminal
of the engine side connector and ground.
There should be continuity with the reverse selector
lever operated and no continuity with the lever
released.
REMOVAL/INSTALLATION
Remove the two bolts and guard plate.
Disconnect the switch connector and remove the
reverse shift switch and sealing washer.
Install the reverse shift switch with a new sealing
washer and tighten it.
TORQUE: 13 N m (1.3 kgf m, 10 Ibf-ft)
Connect the switch connector securely.
UPSHIFT SWITCH
DOWNSHIFT SWITCH
>A 10P GREEN CONNECTOR
2P GREEN CONNECTOR
CONNECTOR GUARD PLATE
REVERSE SHIFT SWITCH, SEALING WASHER
22-22