Table of Contents
Advertisement
BRAKE SYSTEM
Install the drum cover and tighten the six bolts.
Apply molybdenum disulfide grease to a new dust
seal lips and install it into the wheel hub with the
flat side facing in until it is fully seated.
Install the wheel hub onto the axle.
Install the hub nut and tighten it to the specified
torque and further tighten until its grooves align
with the cotter pin hole.
TORQUE: 137 Nm (14 kgf-m, 101 Ibf-ft)
Install a new cotter pin.
Install the right rear wheel (page 14-6).
Adjust the rear brake (page 4-18).
COTTER PIN
REAR BRAKE PEDAL
REMOVAL
Remove the right center mud guard (page 3-6).
Remove the following:
- bolt
- rear brake light switch stay with the switch
- return spring
15-19
Advertisement
Chapters
Table of Contents
Troubleshooting
