Crankcase Bearing - Honda 2005 FOURTRAX FOREMAN TRX500 TM Service Manual

CRANKCASE/TRANSMISSION/CRANKSHAFT/BALANCER
CRANKCASE BEARING
INSPECTION
Remove the crankshaft and balancer (page 12-20).
Turn the inner race of each crankcase bearing with
your finger. The bearing should turn smoothly and
quietly.
Also check that the bearing outer race fits tightly in
the crankcase.
Replace any bearing if the inner race does not turn
smoothly, quietly or if the outer race fits loosely in
the crankcase.
FRONT CRANKCASE BEARING
REPLACEMENT
Remove the balancer and countershaft bearing with
the special tools.
TOOLS:
Countershaft bearing:
Remover shaft, 20 mm
Remover handle
Remover weight
Balancer bearing:
Bearing remover, 17 mm
Remover handle
Remover weight
BALANCER
BEARING
07936-3710600
07936-3710100
07741-0010201 or
07936-3710200 or
07936-371020A
(U.S.A. only)
07936-3710300
07936-3710100
07741-0010201 or
07936-3710200 or
07936-371020A
(U.S.A. only)
COUNTERSHAFT
BEARING
Remove the two bolts and mainshaft bearing set-
ting plate.
Drive the crankshaft, mainshaft, output shaft and
shift drum bearings out of the front crankcase.
# #
SETTING PLATE
CRANKSHAFT
MAINSHAFT
12-24