Drive Belt Installation - KYMCO SUPER 9 50 Service Manual

7
. KICK STARTER/DRIVE PULLEY/
CLUTCH/DRIVEN PULLEY
Remove the drive belt from the clutch/
driven pulley.

DRIVE BELT INSTALLATION

Turn the driven pulley clockwise and lift it
up to expand the drive belt groove and then
install a new drive belt.
Set the drive belt on the drive pulley.
Install the drive pulley face, starting ratchet
and 17mm washer, then tighten the drive
face nut.
Torque: 34.3～39.2N-m
＊
When installing the drive face nut, make
sure that the tooth spaces of the drive
pulley face and starting ratchet align
with the teeth of the crankshaft.
7-7
Drive Belt
Drive Face Nut
Starting Ratchet
SUPER 9 50
Clutch/Driven Pulley
Drive Pulley Face
17mm Washer