Abus SECVEST Installer Manual page 61

Type
HUA Confirm
HUA Confirm Timer
Duress Code
Confirmed Alarm
Fire Alarm
Technical Alarm
24 Hour Alarm
Zone Alarm
Explanation
A confirmed hold up alarm has occurred.
The alarm panel activates the output under the following
conditions:
• Users trigger an alarm at at least two different hold up
transmitters during the hold up confirmation time.
• A hold up transmitter is activated and a tamper alarm
of a hold up transmitter is triggered during the
confirmation time.
This output type can be assigned to one or more partitions.
Note that the hold up transmitter (and tamper alarms) must
be assigned to the same partition.
The output is deactivated as soon as a user resets
the system.
This output is activated while the timer for confirmation of
a hold up alarm is running and is deactivated as soon as
the timer has expired.
A duress code has been used. The alarm panel activates
the output as soon as a user enters a duress code and
deactivates the output again when the user resets the
system.
This output is activated when an alarm is interrupted by
the user in the selected partition during the possible time
period. The output is deactivated again when the alarm is
confirmed.
This output is activated when a fire alarm is triggered.
This output is activated when a zone with the attribute
"Technical Alarm" triggers an alarm. It is only deactivated
again when the zone triggering the alarm is reset
(cause for the technical alarm has been corrected) AND
the user confirms the technical alarm on the alarm panel
with a valid code.
This output is activated when a zone with the attribute
"24 Hour Alarm" triggers an alarm.
This output is activated when the selected zone reports an
alarm and is deactivated again when the alarm is reset.
Configuration
Can be assigned
to partitions
No
No
Yes
Yes
Yes
Yes
Yes
No
61