Abus SECVEST Installer Manual page 147

Function
Signal Strengths
Outputs
Prox Tag
Meaning
This option can be used to check the received signal strengths of all wireless components of
the system.
The number before the brackets is the signal strength of the last received signal.
The number inside the brackets is the smallest signal strength received since the last reset.
The alarm panel records the received signal strengths, even if you do not see them in
this menu.
If you use a WAM as a repeater to strengthen weak signals from wireless components,
you will barely notice a change between the corresponding components. For this reason,
use the display of the signal strength for the corresponding WAM in order to gain
information about the signal strength of the repeated signals from the wireless components.
Press the # button to delete the recorded signal strengths for the selected component.
Detectors
• The display shows the signal strength of each taught-in detector.
• The zone names are displayed. To view the zone numbers, press the right menu key.
Control Devices
• The display shows the signal strength of each taught-in control device.
External Sirens
• The display shows the signal strength of each taught-in wireless external siren.
WAM
• The display shows the signal strength of each taught-in WAM.
Door Locks
• The display shows the signal strength of each taught-in door lock.
Radio Outputs
• Use this option to check all configured radio outputs.
Wired Outputs
• Use this option to check all configured wired outputs.
After exiting the menu, all outputs switch back to their basic configured state.
Move the chip key across the reader area at the bottom of the alarm panel (where the ABUS
logo is).
The following information appears on the display:
• which user is assigned to this chip key or
• that the chip key is not recognised by the alarm panel.
Configuration
147