Checking The Tr069 Status (Flexmaster Management Only); Disconnecting The Ap From The Network - Ruckus Wireless ZoneFlex 7055 User Manual

Checking the TR069 Status (FlexMaster Management
Only)
If you configured the AP to report to a FlexMaster server on the network, make sure
you verify that it can successfully communicate with the FlexMaster server. You can
do this by checking the TR069 status on the AP's Web interface.
1 Log in to the AP's Web interface.
2 Go to the Administration > Management page.
3 Scroll down to the TR069 Status section.
4 Check the value for Last Successful Contact. If it shows a date in green, this
indicates that the AP was able to successfully communicate with FlexMaster.

Disconnecting the AP from the Network

1 Disconnect the AP from the power source.
2 Disconnect the Ethernet cable that runs to the AP's RJ45 port from your
network's router or switch.
You are now ready to deploy the AP in its permanent mounting location.
Ruckus Wireless Indoor AP 100.2.0 User Guide, 800-70892-001 Rev A
Installing the AP
Step 2: Verifying AP Operation
93