Setting Threshold Options - Ruckus Wireless ZoneFlex 7055 User Manual

• Accounting Server: Optionally, enter the information needed to establish
this connection.
6 Click Update Settings to save and apply the changes. A confirmation message
appears at the top of this page.
7 Click Go back to Wireless Configuration to reopen the previous page.
NOTE Ruckus Wireless APs do not support arbitrary rate values for 802.1X clients
(if client rate limiting attributes are configured on the RADIUS server). Ruckus
Wireless APs support only those WLAN rate limiting values that can be set using
the AP web interface. If the rate returned by the RADIUS server does not match one
of these values exactly, it is approximated.

Setting Threshold Options

The following options allow you to fine-tune the "Protection Mode" behavior, set
previously on the Configuration > Wireless > Advanced > Common page. After
activating a Protection Mode, you can open each Wireless tab and customize the
threshold settings, which determine what is put into effect and when.
CAUTION!
administrator or are under the guidance of an IT/support professional.
1 Go to Configuration > Wireless or Configuration > Radio 2.4G or
Configuration > Radio 5G. The Configuration > Wireless > Common page
appears.
2 Click the tab for the Wireless # (WLAN number) that you want to configure. The
Configuration > Wireless > Wireless [#] page appears.
3 Look for Threshold Settings, and then click Edit Settings. The Configuration >
Wireless > Advanced > Wireless [#] page appears.
Ruckus Wireless Indoor AP 100.2.0 User Guide, 800-70892-001 Rev A
Do not customize these options unless you are an experienced network
Configuring the AP
Configuring Wireless Settings
141